| Parameters | Specifications |
| Output voltage | 200 to 4500V ± 10%, 10V step |
| pulse parameters at 50 ohm | Pulse rise time 5ns ±30%
pulse width 50ns ±30% |
| pulse parameters at 1k ohm | Pulse rise time 5ns ±30%
Pulse width 35 ns to 150 ns |
| Polarity | Positive, negative, polarity change burst by burst |
| Pulse frequency | 0.11kHz to 1000kHz ±5%
(0.11kHz to 1kHz at 0.01 kHz step
1kHz to 10kHz at 0.1kHz step
10kHz to 100kHz at 1kHz step
100kHz to 1000kHz at 10kHz step) |
| Burst duration | Number of pulses within a burst: 1 to 1000 or continuous (limited by settings for pulse frequency and burst period)
Settings by number of pulses and duration are available |
| Burst period | 10 to 1000 ms ±10%, 10ms step
(alternative mode: >510 ms) |
| "Continuous" mode operation | 50 KHz max, limited by output voltages |
| Dynamic output Z | 50 ohms ±20% |
| Output connector | coaxial (PULSE OUT), outlet panel |
| Coupling capacitor | 33nF |
| DC blocking capacitor | 10nF ±20% |
| Frequency modulation | deviation: -10% to setting. |
Timer
(test duration) | 1s to 99h 59m 59s
10 minutes max in the "continuous" and alternate polarity modes |
| External trigger | TTL down edge
Minimum trigger interval acceptable: 10ms |
| Burst timing | non-synch. | Irrespective of EUT mains frequency |
| synch. | Synchronizes with the EUT mains frequency
0 to 359 degrees ±2 degrees, 1 degree step
Burst period: 50/60Hz |
| Internal CDN | 85 to 500V AC 50A 50/60Hz
5-wire three-phase, 125V DC 50A |
| Coupling line | L1, L2, L3, N, PE |
| Coupling mode | Line (s) to ground mode only |
| Outlet | Plug receptacle placed on the front panel |
| EUT mains switch | Turn on/off controllable by front panel |
| Emergency switch | Turn off pulse generation and interrupt the EUT mains. |
| Printer interface | Centronics (ESC/P) |
| Included accessories | Line input cable/ Mains cable
Accessory bag / Instruction manual
Outlet panel: 500V AC 50A, 3-pin |
| Optional accessories | GP-IB/RS-232C interface
Coupling clamp
CDN unit
Outlet panel (various types outlets)
Attenuator (50 ohm coaxial attenuator)
Infra-red remote controller
Memory card
Warning lamp
Printer cable |
| Ambient (operation) | 10 to 40 degrees, 25 to 75% relative humidity |
Dimensions and
(projection included) | (W) 332 x (D)443 x (H)420 mm |
| Weight | 20 kgs. |
| Power supply | 90V to 264V AC, 50/60 Hz |
